How to wash and care for karting gloves
· 6 min read
How to wash and care for karting gloves: hand washing, drying, storage and signs of wear. Simple habits that keep your gloves fitting well for longer.
Karting gloves work harder than you might think. Sweat, track dust, bits of tyre rubber – and, if you race in a sim, hours of contact with the wheel rim. Neglect them and they will soon start to smell, stiffen and lose their fit. Fortunately, looking after them is simple and only takes a few minutes. Here is how to wash and care for karting gloves so they last as long as possible.
Before you start: check the label
Every pair of gloves can come with slightly different manufacturer instructions. Before doing anything, look at the care label. If the manufacturer's advice differs from what follows, it always takes priority. The tips below are a cautious, general approach that is safe for most gloves.
Everyday care after driving
Most of the work happens right after you leave the track or get up from the cockpit:
- Take the gloves off carefully. Don't pull them off by the fingertips – that stretches the seams. Loosen the cuff first, then slide the glove off from the wrist.
- Turn them inside out or open the cuff. The inside needs to dry. Gloves balled up and thrown into a kit bag are a recipe for bad smells.
- Leave them somewhere airy. Ideally flat or hung by the cuff, at room temperature.
- Remove dust from the outside. After a track session, shake off the dust or wipe the surface with a slightly damp cloth.
This routine means a full wash is needed far less often.
How to wash karting gloves step by step
How often? That depends on how hard you drive and how much you sweat. For most drivers, a wash every few sessions – or whenever the gloves start to smell or look dirty – is enough.
1. Prepare lukewarm water
Fill a bowl or basin with lukewarm water, around 30°C. Hot water can deform the gloves, weaken bonded parts and make components shrink.
2. Use a mild detergent
A small amount of gentle liquid detergent (for example one for delicates) or a mild soap is all you need. Avoid bleach, chlorine-based stain removers and fabric softeners – they can fade the red accents, damage prints and change the texture of the grip side.
3. Wash gently by hand
Put the gloves on and "wash your hands" in the soapy water, just as you would with bare hands. It is the easiest way to clean the whole surface without stretching anything. You can gently scrub stubborn dirt with a soft brush. Don't wring the gloves.
4. Rinse thoroughly
Rinse in clean lukewarm water until no more suds appear. Leftover detergent makes gloves stiff and can irritate your skin.
5. Press out the water without wringing
Squeeze the gloves gently in your hands, then roll them in a dry towel and press lightly. The towel will soak up most of the moisture.
Drying – where most mistakes happen
How you dry the gloves decides whether they keep their shape and softness.
- Dry them flat on a towel or a drying rack, or hang them by the cuff.
- Keep them away from radiators, stoves and direct sunlight. High heat makes gloves stiffen, shrink and crack.
- Never use a tumble dryer or a hair dryer.
- Shape the fingers while the gloves are still damp so they dry in their natural form.
- Be patient. Fully drying can take a day or more. Don't wear damp gloves – on track or in the sim.
Can you machine wash karting gloves?
We advise against it unless the care label clearly allows it. A washing machine is hard on gloves: the spin cycle stretches seams, can damage prints and the raised pads on the back, and high temperatures deform the gloves. Hand washing takes a few minutes and is much safer.
Storing gloves between seasons
If you drive seasonally, prepare your gloves before a long break:
- wash them and make sure they are completely dry,
- store them in a cotton or mesh bag, not a sealed plastic one,
- keep them somewhere dry and dark, at room temperature,
- don't crush them under heavy items – the raised pads on the fingers can be permanently deformed.
In your kit bag, don't stuff the gloves inside your helmet. Moisture from the gloves is bad for the helmet lining, and the gloves lose their shape in there.
When to replace your gloves
Even well-kept gloves wear out eventually. It's time for a new pair when you notice:
- worn patches or holes on the palm, especially where you grip,
- splitting or opening seams, particularly between the fingers,
- a stretched wristband that lets the glove slip,
- lost fit – the glove no longer sits close and the material bunches under your fingers,
- a smell that won't go away despite washing and proper drying.
Worn gloves mean a poorer grip and less precision at the wheel – which is exactly why you wear them in the first place.
Caring for sim racing gloves
If you use your gloves for sim racing, the same rules apply, but they usually need airing more often – there is no track dust at home, but plenty of sweat. Never leave damp gloves on the wheel: moisture is bad for Alcantara and leather rims. Read more in sim racing gloves – are they worth it and how to choose.
The key rules at a glance
- After every drive: air them, don't ball them up.
- Hand wash in lukewarm water with a mild detergent.
- Rinse thoroughly, never wring.
- Dry flat, away from heat, no tumble dryer.
- Store somewhere dry and airy.
- Replace them when you see worn patches, split seams or lost fit.
Good care also starts with the right size – gloves that are too tight stretch and split at the seams sooner. If you are planning a new pair, check our size guide or browse karting gloves.
